What is the cost of a false ceiling per sq ft?

Gypsum board ceilings and POP ceilings are both priced per sq ft on InteriorIQ's rate card. Gypsum work costs ₹75–140 per sq ftFrom InteriorIQ's rate card rc-2026-10-11. Ranges, not a quote. per sq ft. POP costs ₹60–120 per sq ftFrom InteriorIQ's rate card rc-2026-10-11. Ranges, not a quote. per sq ft. Gypsum boards install faster and give smoother joints. POP is shaped on site, so its finish depends more on the craftsman's skill.

PVC and wood are not priced as full false-ceiling items on the rate card. Most homes use them for panels or accent sections, not the whole ceiling. A wooden panel ceiling section costs ₹250–500 per sq ftFrom InteriorIQ's rate card rc-2026-10-11. Ranges, not a quote. per sq ft in Delhi NCR. This gives a sense of cost against gypsum and POP.

• Gypsum board ceiling: faster install, smooth joints, medium relative cost, moisture-resistant boards available for wet areas
• POP ceiling: lower to medium relative cost, slower install, finish depends on the craftsman
• Wooden panel section: priced separately, used for accents rather than full ceilings, with veneer finish and polish
• Ask the vendor whether the quote is per sq ft of ceiling area or per running foot of frame

The ceiling area in sq ft is the base of any false ceiling quote. It is not the same as the floor area of the room. A plain gypsum ceiling, built with a galvanised metal frame and gypsum boards, costs ₹75–140 per sq ftFrom InteriorIQ's rate card rc-2026-10-11. Ranges, not a quote. per sq ft. Adding a cove profile for cove lighting raises the rate to ₹100–170 per sq ftFrom InteriorIQ's rate card rc-2026-10-11. Ranges, not a quote. per sq ft.

Design complexity also changes the price. A flat single-level ceiling costs less than one with steps or curves, since it needs less frame work and fewer joints. Cut-outs for recessed lights and LED profiles add labour beyond the base board rate. A ceiling with many light points costs more than a plain one of the same area.

InteriorIQ builds each range by multiplying a per sq ft rate from the rate card by the ceiling area measured on site. This follows the methodology published alongside rate card rc-2026-10-11.

A flat gypsum or POP ceiling needs frame depth below the slab. The room loses some height wherever the ceiling is installed. Homeowners usually check the clearance between the slab and any beams, pipes or ducts before fixing a design. This clearance decides how low the ceiling can sit.

Choosing a shallower frame, or skipping a cove profile, limits both the height lost and the price. A common mistake is picking a cove design for a low-ceiling room without checking the drop with the installer first. This can mean redoing the design after work has started.

InteriorIQ uses the same per sq ft ranges across Delhi NCR. This covers Noida, Greater Noida West, Gurugram, Ghaziabad, Delhi and Faridabad. The rate card does not add a locality premium on top of these ranges.

Quotes seen locally usually differ because of which studio or contractor is pricing the job, not because of a fixed area-based markup. Ask any vendor quoting for Noida, Gurugram or elsewhere whether their number sits inside the rate-card range before accepting it.

The per sq ft price usually covers the frame, boards and one primer coat. It does not include lights, fixtures, LED strips or their drivers. These get added once the design and light points are finalised.

Final paint and GST are usually excluded from the quoted range, unless the quotation says otherwise. Check both lines before comparing two quotes. A cove profile is priced separately from a flat gypsum ceiling. Confirm which row of the price table applies to your design.